From the monthly archives:

July 2008

The madness of planning

by Suw on July 13, 2008

Andrea Lightwood and her family started what could have been a dream barn conversion earlier in this year. Getting planning permission for barn conversions is, by all accounts, rather tricky, but the Lightwoods managed, and they broke ground on Feb 20th. Things seemed to be going fairly well until winds were forecast on March 10th, and at 3am on March 12th, a gust of wind blew down the barn despite it having been supported with scaffolding to protect it from the heavy weather. Just one gable was left standing.

This would be a set-back for anyone. It would mean either rebuilding with the original materials or rethinking the entire conversion and starting again with a new build. But the UK’s planning policies don’t work like that. Because the structure was damaged, the planning permission for the conversion was automatically revoked. In one gust of wind, Andrea Lightwood’s entire build was destroyed, not just the old barn’s walls. She says:

Just as I originally thought our planning has now disintergrated along with the mortar that was holding the bricks in place.

After a meeting with Building control officers and Building inspectors, Building control returned to their offices and we awaited the decision …….can we continue’building’ under the original planning application? Of course not…the reason? we had not supported the barn using the most appropriate best methods. !!!!!!!!!!!!

We had sought advice and tried, I resent garage dwelling and spending un necessary money the barn was my dream, why would we not have protected it properly?

Despite the fact that the weather across the UK has been unusually violent this year, and despite the fact that the Lightwoods had put scaffolding up to brace the structure, the planning officers decided to revoke permission, just like that.

On May 21st, Andrea submitted new plans, but on July 2nd, planning permission was refused:

Due to various local planning polices the application has been refused as it is classed as a ‘new dwelling in the country side’ and is therefore harm full to the environment.

Erm, so let’s get this straight now, shall we? There was a building on this site that had stood for quite a while. The majority of that building blew down, thus returning the site immediately to something akin to ‘green field’ status which means that rebuilding the barn would actually be building a new structure which means it contravenes the green field policy?

That is insanity. If it was ok for there to be a barn there, and it was ok for that barn to be converted into a house, then what possible reason could there be for not continuing with that build? It entirely defies logic and reason.

Matt Sims of the Wrexham Leader has covered Andrea’s plea to councillors to let her rebuild:

The council’s planning policy forbids the building of any new dwellings in the countryside and officers recommended Mrs Lightwood’s application be refused.

At a meeting this week, however, councillors agreed to pay a visit to the site of the proposed development to assess what kind of impact it would have on the surrounding area following an appeal by Mrs Lightwood.

[...]

Planning control manager Bob Dewey said that because it contradicted council policy, officers had no choice but to refuse.

“The applicants made a very passionate plea on behalf of the proposal,” he said.

“It is something that was approved as a conversion, has now substantially gone and clearly would be in breach of our policy. With regret, our recommendation has to be to refuse.”

Planning chief Lawrence Isted said: “It’s a fundamental policy of principle and it wouldn’t be a small matter to put it to one side.”

“No choice”? Absurd. If there was a building there before which was approved for conversion into a dwelling, what is the harm in allowing that build to go ahead? Materially, what has changed? Not the environment. Not the quality of the land - it hasn’t suddenly returned to pasture. Not access to the land. Not the distance of the plot from the nearest village. All that has changed is that some bricks that were vertical are now horizontal.

There’s no doubt that planning policy at a national and a local level are out of step, but this is taking local planning pedantry to a new level of absurdity. I can only hope that sense prevails and that Andrea gets to build her house.

{ 4 comments }

Make your own automatic cat tap

by Suw on July 13, 2008

One of the reasons that I love cats so much is that they are, like me, very finicky - particularly regarding what they eat and drink. How many cat owners have put down a perfectly clean bowl of water, only to watch their cat turn their nose up and go and drink from the toilet or the bird bath? Mmm!! Tastes like sparrow!

Fflwff always preferred drinking from the bathroom sink, so I’d often turn the tap on for her whilst I was doing something else, turning if off when she was done. She’s a bit old now to be jumping up to the sink, but if she had her druthers that’s where she’d drink. Trouble is, it’s a bit tedious to keep getting up to turn taps on and off.

Now, thanks to the ingeniousness of Sixerdoodle Electronics, you can now make your own kittie-controlled tap, so that your moggie can have a drink as and when s/he wants without bothering you, and without wasting water. (Covered also by Make and Engadget.)

The system uses an infrared sensor to detect when the cat is near, and a 1/4 inch tube to deliver the water to the thirsty kittie. You can also set it up to detect when a human is near, so that the kittie tap doesn’t turn on when the human puts their hands in the sink.

You need to have a few plumbing and electronics skills, but if you’re including such a system in your self-build, you can always design it in from the beginning and get your tradesmen to do the work. You can order a complete kit for just $90 (about £45 at today’s exchange rate), or download the schematics and pull together the bits yourself.

This puts it roughly on a par with commercially produced cat fountains, such as the Drinkwell Platinum Pet Fountain or the Catit Drinking Fountain, but has the added advantage of never requiring a refill as it’s drawing water from the mains.

Personally, I shall definitely be including a IR sensor controlled cat drinking fountain in my house - I can very easily imagine a wet room or kitchen that includes a spout in the wall and a small bowl at about cat height, a bit like this old Roman drinking fountain:


Thanks Papalars.

I’m sure our FutureKitties would be very happy with such an arrangement.

(Thanks to Peter for the heads-up!)

{ 0 comments }

Reusing grey water

by Suw on July 7, 2008

When I was at Grand Designs Live, one of the products I stumbled upon was Ecoplay, from CME Sanitary Systems. They system is a fairly small and compact processing unit for grey water, e.g. shower and bath water, cleaning out the muck and making it clean enough to use for flushing the toilet. It’s a great idea - reducing the amount of water that we use by up to 30%. From the website:

Greywater from the bath and shower is collected in the Ecoplay cleaning tank where a skimmer removes surface debris such as foam, hairs and soap. Heavier waste particles sink to the bottom and are flushed away to waste. The remaining ‘clean’ greywater is then transferred to a storage tank ready for use in toilet flushing. The storage capacity of the system is 100 litres – sufficient for approximately 20 flushes.

Intelligent operation:

* If the toilets are not flushed within 24 hours after a period of regular use, (e.g. when the house is empty) the system purges any retained water to waste
* This also cleans the system and prevents retained water becoming stale
* The system then draws in a minimal amount of fresh mains water to allow toilet flushing
* A power failure causes all stored water to be drained off immediately

Not only that, but Ecoplay means that you can subtract water used for flushing toilet from your water calculations when your home is being assessed against the Code for Sustainable Homes, allowing you to improve your rating.

The only aspect about Ecoplay that I wasn’t sure about was whether there is an issue with the waste from the Ecoplay system - basically all the bits that it skims and filters out of the waste water before it gets pumped back into the toilet system - and off-grid water processing. I did ask the chap at their stand, but he didn’t seem to quite understand what I was was asking, so I gave up. I guess I just need to learn a lot more about off-grid water processing so I can figure it out for myself.

{ 0 comments }

A bath to die for

by Suw on July 5, 2008

I love baths. As a kid, I hated them: the old enamel bath sucked the heat out of the water as soon as you got in and our ParkRay fire struggled to provide enough hot water for a bath and the radiator, so in the winter the temperature in the bathroom would be uncomfortably cool. And I am allergic to soap, so baths used to make me itch, until some nice scientist invented shower gel.

Now, I love baths. There is nothing better at the end of a long day than a soak in the bath, with a glass of wine and my husband reading to me. Aaah, bliss. Our bath, however, is so small that you end up sitting in a puddle with your knees around your ears, which is not the most relaxing of positions.

And the water still goes cold.

Enter the BathOMatic Eco, a bath control system that fills the bath itself, prevent overflowing, and keeps water at a consistent temperature. Oh, I want one! But wait… there’s the BathOMatic Eco Ultimate, which adds an automated fragrance and bubblebath dispenser. Or the BathOMatic Eco Whirlpool Ultimate, with all the features above and a spa setting for the most relaxing bath ever! I have seen - and been in - many beautiful baths in my time, but a bath that sets and keeps a constant temperature would be just heaven.

Mind you, heaven doesn’t come cheap. The SelfBuild & Design magazine priced the basic BathOMatic at £6463, inc. VAT. And that doesn’t include the bath, as the website says “bathomatic can be added to any bath, including retro-fit, and by any qualified and competent plumber.”

And, for the geeks amongst us, the BathOMatic can be controlled from “any location via a LAN”, meaning that Kev could control my bath from his computer… which could be a good or a bad thing, depending! And to top it all, the brochure includes a photo of an iPhone interface for the control system, which seems to indicate that I could run my bath whilst I was on my way home.

This definitely goes on my wishlist!

{ 0 comments }

Shed of the Year Awards: Vote now!

by Suw on July 2, 2008

We love sheds here at Kits and Mortar, although until someone invents a levitating shed that we can install outside our 2nd floor flat, we’re going to have to make do with the lovely sheds over at Shedworking. Who, incidentally, emailed me today to remind me that you have until the end of the week to vote in the Shed of the Year Awards. The question on my lips is, will one of the Tardis sheds win? (And are they bigger on the inside…?)

{ 0 comments }

I’ve been voraciously devouring every self-build magazine I can lay my hands on since starting Kits and Mortar and have gathered quite a little collection. I thought that it’d be a good idea to review the magazines that I’ve got, and to do issue summaries too. The latter will allow me to keep a track of the articles that I think were interesting or useful, rather than to provide a full summary of what that issue contains. Anyway, on with the first magazine review, Homebuilding & Renovating.

Homebuilding & Renovation is a monthly title costing £3.99, with subscriptions of £38.75 for 12 issues and £18 for six issues. It has a strong focus on case studies, typically including five or six houses, ranging from million pound homes through to budget builds, covering a wide variety of styles. It also has a lot of practical advice, with six or seven articles in the Project Advice section, and several more useful columns and articles in the Building Talk section. It looks at materials, techniques, design issues, technology, legal issues, landscaping, regulations, and planning - and that’s just in the three issues I have!

This comprehensive remit focused on the practical really does make H&R a useful magazine for me, as I’m learning a lot. These are magazines that I’ll keep and refer back to in the future, when the information becomes more directly relevant to my own project. H&R also has a Beginner’s Guide, which is very useful for people like me who are just at the very start of their self-build journey.

The nice thing about H&R is that it is enthusiastic and informative without being pretentious or condescending. Sometimes I get a bit lost with the jargon, but that happens very rarely. I like the tone of voice the writers use - H&R is an approachable, readable magazine - however I’d like to see much more attention paid to green issues and sustainability. They do cover environmental issues occasionally, but they need to embed awareness in every article. I’d particularly like to see them rate the houses they feature for environmental responsibility, not just in terms of energy use but also the sustainability and environmental impact of materials used.

H&R’s online presence is currently quite poor due to “acute technical difficulties”, however they do provide a look inside their current issue, which provides you with access to the magazine’s contents pages, and the first two pages of a number of articles. That’s just enough to give you a feel for what’s on offer, but you can’t actually read anything useful. I’ll be interested to see what H&R do with their new website, and will report back then.

Sadly, there is almost no integration between online and the magazine, except a quarter page “Webtalk” section which reprints comments made in their discussion forum, and a few URLs. Other than that, you would imagine that the internet didn’t exist. That’s a shame, but entirely unsurprising. Maybe I should pitch them an article or two!

Overall, though, I highly recommend H&R. Thumbs up!

{ 0 comments }

links for 2008-07-01

by Suw on July 1, 2008

{ 0 comments }